#WINDOWS TERMINAL SERVER 2008 CAL INSTALL#
#WINDOWS TERMINAL SERVER 2008 CAL SOFTWARE#
#WINDOWS TERMINAL SERVER 2008 CAL WINDOWS#

Posted in: Small Business Server 2003 R2, Software Development, Team Foundation Server. I hope this helps someone get back up and running faster than I did… Posted: February 3, 2007. Wait a few minutes for things to get up and running and you’re no ready for remote administration again.

Make sure administrators is in the list.

(because removing Terminal Server disables this)

Check Enable Remote Desktop on this computer.

Open System control panel applet (run “sysdm.cpl”).

Follow instructions, including rebooting.

#WINDOWS TERMINAL SERVER 2008 CAL WINDOWS#

Click Add/Remove Windows Components (Alt-W).Run Add/Remove Programs (run “appwiz.cpl”).The process requires that Terminal Server be uninstalled, the server rebooted, and Remote Desktop be re-enabled. Clearly a WTF moment.Īs it turns out, the hoops to get back to the ability of remote administration aren’t clearly documented (I actually couldn’t find any documentation on the process, I actually inferred the process from various non-Microsoft sources–there could be documentation somewhere, I just didn’t find it). Apparently I missed the memo that remote administration is now called “Remote Desktop”. I was used to installing Windows Server and setting up Terminal Server for remote administration (there was a setting for that in Windows Server, I honestly don’t remember what Small Business Server asked me when I installed it certainly wasn’t clear it was different the other Windows Server installation processes). After a bit of searching, it appears it was the 120 day anniversary of creating this server and Terminal Server (which is what is used for an application server in Small Business Server) had “expired” (i.e. Needless to say I was dumbfounded–it worked fine yesterday. If you are not a member of the Remote Desktop Users group or another group that has these permissions, or if the Remote Desktop User group does not have these permissions, you must be granted these permissions manually. By default, members of the Remote Desktop group have these permissions. To log on to this remote computer, you must have Terminal Server User Access Permissions on this computer. I was greeted with a message box as I logged in:

#WINDOWS TERMINAL SERVER 2008 CAL INSTALL#

Well, I finally had a couple of cycles to install some hotfixes for the new daylight savings time changes to various components, so I sparked up RDC to get the ball rolling on my server–as I have done many times before. So, I’ve been merrily using Remote Desktop Connection (RDC) in Windows XP to connect to this server to perform my various administration tasks (like install service packs, hot fixes, etc.). I don’t have it hooked up to a monitor (one: don’t have that many monitors, and two: desk space). I have a Small Business Server 2003 R2 Server running Team Foundation Server tucked out of the way to conserve desk space (three servers, two clients, two desks: not much space).

Windows terminal server 2008 cal